Oct 04, This is another C4 that had upper control arm work that represents a factory control arm shaft.
The upper control arm shafts use the concave thick washers to center and retain the shafts. Make sure the concave side goes towards the control arm shaft, there will be two of these concave washers, one on each side of the shrubpruning.buzzted Reading Time: 12 mins.
May 15, Now remove the cap screws, lock washers, and collars from both ends of the control arm shaft. Step Install a 3/×2¼” cap screw in one end of the shaft.
Place the control arm in a press and support one bushing end of the control arm shaft with a 1 11/16” socket. Now press out the bushing into the shrubpruning.buzzted Reading Time: 7 mins.
Dec 05, redvette89 Standard Member Send Private Message Huron, OH - USA Vette(s): Red Convertible -fun-filled miles - Joined: 12/5/ Posts: Jan 04, Four trailing arms, or spindle control rods, hold the rear axle in place. On the earlier Corvettes a single trailing arm was used. From to an arm was attached to the frame and ran towards the rear of the car. This trailing arm held the rear spindle in place. The C4 design is really just an improvement on that earlier shrubpruning.buzzted Reading Time: 6 mins.
C4 CORVETTE Front Control Arm Bushings Polyurethane UPPER / LOWER BLACK - EUR 89, À VENDRE! New Energy Suspension control arm bushings. These bushings are made from Polyurethane, Prothane Chevy C4 Corvette Rear Control Arm Bushing Insert Kit Red. 10mm Carburetor Primer Bulb For 26 33 cc 2 Stroke Kragen Zooma Bladez Scooter, ANZO LED 3rd Brake Light Smoke B-Series For DODGE RAMUsed Honda.